![]() all ready for flashing:Īfter that is done, head over to and follow the wizard to flash your device. This is a bit of an odd step, as you will need to unfold a paperclip and plug it into a couple of the pins on your C.H.I.P. In order to perform a flash, you will need to put your C.H.I.P. As it turns out, in the 4.4 firmware at least, it is! ![]() to get the latest and greatest image for the device and hope this was resolved. I also hadn’t used the device in quite a while, so I figured it was a good idea to reflash my C.H.I.P. Apparently, /dev/ttyUSB0 should have been a choice, and it wasn’t there. ![]() firmware didn’t include the USB Serial drivers in the kernel. After some searching around (most of the stuff out there is for the Raspberry Pi, which is a very similar device) it seems like the first builds of the C.H.I.P. It wasn’t connecting to the printer, and when I installed Repetier-Server it couldn’t find the printer. right after I got it so I could use the VGA adapter I got with it, but when I tried to set it up (monitor, keyboard, and all) connected to the 3D printer, I ran into some issues. Besides the instructions themselves, another major intent of this article is just to say that yes, it works, and it doesn’t require a lot of convoluted process to set up. pretty much the only thing I found was “it should” and some references to running it on the Raspberry Pi. When I went looking to see if Repetier-Server would run on the C.H.I.P. If you are an experienced Linux user, this is a very straightforward process. I had been using Repetier-Host on my PC with its embedded Repetier-Server, so I really wanted to keep using the software as it was my favorite of the 3D printing apps I’ve tried so far. kickstarter a while back, and had a $9 computer I had played with for a while and then not gone back to, so it seemed like a great opportunity to put it to use. My wife got me a 3D Printer (the MonoPrice Maker Select V2) for Christmas, and while I initially had it connected directly to my PC, when I rearranged things it was no longer close enough to be practical to connect with a USB cable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |